Category: Shower Chairs∨g=

Adaptive/Assistive 3.5 mm Button

AbleData does not produce, distribute or sell any of the products listed on this website, but we provide you with information on how to contact manufacturers or distributors of these products. If you are interested in purchasing a product, you can find companies who sell it below.

The Adaptive/Assistive 3.5 mm Button is a 3D printable AT button. This device interfaces with a 3.5 mm mono jack system. The device is intended for individuals with physical disabilities. AT buttons can be used for individuals with limited range of motion to control his or her environment. The buttons can be used to adapt toys and home appliances so that they can be actuated with ease.

Technical Specifications: 

Matierals: 

  • Cherry MX Switch
  • 3.5 millimeter Mono Port 
  • 6 inches of wire
  • Optional: Compression spring for adjusting the buttons' actuation force
  • Optional: 3.5 millimeter Mono Cable to connect the button to things
  • Optional: drawer/shelf/toolbox liner or dual-lock or velcro as a grip base

Assembly:

  • Print the button base, button hatch, and and key cap.
  • Solder the MX switch to the mono port with two pieces of wire, about 3 inches each.
  • Install the MX switch in the middle of the button base, and then run the mono jack to the port on the flat side. Screw the mono port's threads into the hole in the side of the button.
  • Jam the key cap onto the cherry MX switch. This can optionally be done with a light spring over the switch stem to adjust the force of the button. 
  • Optionally glue or bolt (M3 bolts) the shelf liner to the bottom of the button to make a no-slip base!

Can also optionally have superglue to hold things together.

Available

Price Check
as of: 
08/03/2016
Additional Pricing Notes: 
Contact Vendor
Adaptive Assistive Button